Z86E08 |
RFQ for Z86E08 Required Field |
 |
| Product | Manufacturers | Pack | D/C |
| Z86E08 | - | - | - |
Zilog's Z86E04/E08 Microcontrollers (MCU) are One-Time Programmable (OTP) members of Zilog's single-chip Z8® MCU family that allow easy software development, debug, prototyping, and small production runs not economically desirable with masked ROM versions.
For applications demanding powerful I/O capabilities, the Z86E04/E08's dedicated input and output lines are grouped into three ports, and are configurable under software control to provide timing, status signals, or parallel I/O.
Two on-chip counter/timers, with a large number of user selectable modes, offload the system of administering real-time tasks such as counting/timing and I/O data communications.
Features |
| `14 Input / Output Lines`Six Vectored, Prioritized Interrupts (3 falling edge, 1 rising edge, 2 timers)`Two Analog Comparators`Program Options: Low Noise ROM Protect Auto Latch Watch-Dog Timer (WDT) EPROM/Test Mode Disable`Two Programmable 8-Bit Counter/Timers, Each with 6-Bit Programmable Prescaler` WDT/ Power-On Reset (POR)` On-Chip Oscillator that Accepts XTAL, Ceramic Resonance, LC, RC, or External Clock`Clock-Free WDT Reset` Low-Power Consumption (50 mw typical)` Fast Instruction Pointer (1ms @ 12 MHz)` RAM Bytes (125) |
Stresses greater than those listed under Absolute Maximum Ratings may cause permanent damage to the device. This is a stress rating only; functional operation of the device at any condition above those indicated in the operational sections of these specifications is not implied. Exposure to absolute maximum rating conditions for an extended period may affect device reliability. Total powerdissipation should not exceed 462 mW for the package.
Power dissipation is calculated as follows:
Total Power Dissipation = VDD x [IDD - (sum of IOH)]
+ sum of [(VDD - VOH) x IOH]
+ sum of (V0L x I0L)
| Parameter | Min | Max | Units | Note |
| Ambient Temperature under Bias | 40 | +105 | C | |
| Storage Temperature | 65 | +150 | C | |
| Voltage on any Pin with Respect to VSS | 0.7 | +12 | V | 1 |
| Voltage on VDD Pin with Respect to VSS | 0.3 | +7 | V | |
| Voltage on Pins 7, 8, 9, 10 with Respect to VSS | 0.6 | VDD+1 | V | 2 |
| Total Power Dissipation | 1.65 | W | ||
| Maximum Allowable Current out of VSS | 300 | mA | ||
| Maximum Allowable Current into VDD | 220 | mA | ||
| Maximum Allowable Current into an Input Pin | 600 | +600 | A | 3 |
